Millworker Help Printable version
Help / Features

CAM Corners

Part

Dog-ear the square inside corners a round CNC cutter cannot reach, so square parts fit.

Set up
  1. Click CAM Corners.
  2. Click the panel faces the cutter comes in from (several; click one again to take it back). Every square inside corner running from that face previews in red.
  3. Check the Radius (the part's CAM_RADIUS, 1/8″, for a 1/4″ cutter).
  4. Apply or OK.
Screenshot placeholder images/cam-corners-preview.png 1600 × 900 px Close view of a panel with a notch and a stopped slot, CAM Corners previewing red dog ears in every inside corner.
CAM Corners: a dog ear in every square inside corner.
CAM Corners: a dog ear in every square inside corner.

Each dog ear is a round cut of the radius, its centre the radius from the corner into the open side, so it runs through the very corner. A pocket's floor is not cut into. One node per face; double-click it or change MW_DogEars#_Radius to change it. Dado Join, Halving and Stop Shoulder add CAM Corners for you.