Which panels show in parts, assemblies and drawings, and what each tool is for.
The Millworker tab changes with the document. Settings is always the first panel.
Screenshot placeholderimages/ribbon-part.png1920 × 200 pxA part open. Crop to the full width of the ribbon showing the Millworker tab: Settings, Joins, Fasteners, Features, Treatment, Tools, Mass, Flat panels.
The Millworker tab in a part.
Screenshot placeholderimages/ribbon-assembly.png1920 × 200 pxAn assembly open. Crop to the ribbon showing the Millworker tab: Settings, Panel Marking, Materials, Drawing, Hardware, Tools, Flat (and NestCAM and CabinetCAD if installed).
The Millworker tab in an assembly.
Screenshot placeholderimages/ribbon-drawing.png1920 × 200 pxA drawing open. Crop to the ribbon showing the Millworker tab: Settings, Callouts, Align, Mark Types, Output, Sheets panels.
Add-on products. NestCAM, Cut List, CabinetCAD and Veneer Match are separate products that run on top of Millworker. They need Millworker installed and licensed, add their own panels or buttons to the Millworker tab, and each has its own help, opened from its own Help button.
A panel Inventor kept from an earlier session where it no longer belongs is taken off when Inventor starts, so the tab always matches this list.