Help / Fasteners
Dog Bone
Part
Dog bone pockets for countertop and subtop clamps, across a joint, spread from front to back.
Set up
- A subtop or countertop joint: two panels butting, or one panel with a sketch line drawn on its face where the joint goes.
- Click Dog Bone (Fasteners panel).
- Click the joint's centre line: the edge where the two panels meet, or a sketch line on the face.
- Click the front edge, then the back edge (both across the centre line).
- Check the sizes, and Flip to cut them from the opposite face (the underside) instead of the face the line is on (remembered for next time).
- Apply or OK. The preview shows the dog bones in red.
Each dog bone is two holes, one each side of the centre line, joined by a slot for the clamp's bolt, cut through every panel under it.
| Value | What it is |
|---|---|
| Hole diameter | Each hole (35 mm to start, for a Häfele-style clamp). |
| Centres distance | Hole centre to hole centre, across the joint (100 mm). |
| Slot width | The slot between the holes (12 mm). |
| Depth | How deep they are cut (18 mm). |
| From ends distance | The first and last dog bone, in from the front and back edges (3″). |
| Max gap | More are spread evenly between so none are further apart than this (24″). With no room for two, one goes in the middle. |
Every size is a parameter (MW_DogBone1_Hole, _Centres, _Slot, _Depth, _FromEnd), and the dog bones are spread over the measured front-to-back length, so they follow the panel when it changes. How many there are is set when they are made: make them again for more or fewer. Double-click the DogBone node to change its parameters. The values you use are the starting values next time.