Millworker Help Printable version
Help / Fasteners

Cam Dowels

Part

Bore cam fittings and their dowels in pairs on the System 32 layout.

Set up

The picks and layout are the same as Dowels: the side's inside face, its front edge, then each butting panel's inside face. Each pair is a cam fitting and a dowel.

HoleSizeWhere
Cam housing15.5 mm × 13.5 mm deepIn the butting panel's inside face, 34 mm in from its end.
Rod8 mm × 34 mmIn the butting panel's edge.
Thread end5 mm × 12 mmIn the side's face.
Screenshot placeholder images/cam-dowels-preview.png 1600 × 900 px Cabinet bottom butting a side, Cam Dowels previewing: red cam housings in the bottom's inside face, edge holes and side holes.
Cam Dowels previewing the cam housings, rods and dowels.
Cam Dowels previewing the cam housings, rods and dowels.

Settings… holds the shop's cam setup and the pairs per joint. Parameters are MW_CamDowels#_…, including CamFromEnd. Each housing, bolt hole and dowel is tagged for Place Hardware.