Millworker Help Printable version
Help / Treatment

Shaker Door

Part

Split a door slab into a 5-piece shaker door: stiles, rails with stub tenons, and a floating panel.

Set up
  1. Click Shaker Door (Treatment panel).
  2. Click the door's front face.
  3. Check the sizes in the toolbar. Rotate 90° puts the stiles on the short sides, for a door lying sideways.
  4. OK.
Screenshot placeholder images/shaker-door-preview.png 1600 × 900 px A 15 x 30 in door slab, front face picked, preview showing the stile/rail split and the grooves.
Shaker Door previewing the split of a slab.
Shaker Door previewing the split of a slab.
Screenshot placeholder images/shaker-door-result.png 1600 × 900 px The finished shaker door in an exploded or section view (or with the panel hidden) showing the stiles, rails with stub tenons and the panel; the browser showing … Stile L, … Rail T, … Panel bodies.
The five members, each a body of its own.
The five members, each a body of its own.
ValueDefault
Stile and rail width2.25 in
Panel thickness0.25 in
Groove depth0.375 in
From front0.25 in (the groove's distance back from the door's front)
Gap0.0625 in (the panel stops this short of the groove bottoms)

The slab is split into two full-height stiles, two rails between them and the centre panel. Every member gets a groove on its inside edge, the panel's thickness plus the dado clearance wide. The rails get stub tenons into the stiles' grooves. The panel is thinned to its thickness and grows into the grooves.